Abstract
This study explores the hot deformation behavior of Al–Zn–Mg–Cu alloy through uniaxial hot compression (200 °C–450°C) using the Gleeble-1500. True stress–strain curves were corrected, and three models were established: the Arrhenius model, strain compensated (SC) Arrhenius model, and strain compensated recrystallization temperature (RT) segmentation-based (TS-SC) Arrhenius model. Comparative analysis revealed the limited predictive accuracy of the SC Arrhenius model, with a 25.12% average absolute relative error (AARE), while the TS-SC Arrhenius model exhibited a significantly improved to 9.901% AARE. Material parameter calculations displayed variations across the temperature range. The SC Arrhenius model, utilizing an average slope method for parameter computation, failed to consider temperature-induced disparities, limiting its predictive capability. Hot processing map, utilizing the Murty improved Dynamic Materials Model (DMM), indicated optimal conditions for stable forming of the Al–Zn–Mg–Cu alloy. Microstructural analysis revealed MgZn2 precipitation induced by hot deformation, with crystallographic defects enhancing nucleation rates and precipitate refinement.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
