Abstract
Abstract The urgency of the investigation of finishing and deburring treatment of small parts of radio electronic equipment is justified. It is shown that vibro-abrasive treatment is the most effective method of small parts with hard-to-reach areas deburring and has a number of advantages over other methods since treatment of the parts of this kind is a complicated and hard-to-solve task due to difficult access to the operating area and bending of burrs inside grooves and holes. The results of theoretical and experimental investigations on the process of deburring during vibration treatment of parts are presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
