Abstract
The effects of corrosion methods, galvanostatic (GS) vs. artificial climate environment (ACE), on the relationships between corrosion products and corrosion cracks of corroded reinforced concrete beams are investigated. The experimental results show that the GS method induces smaller corrosion crack width. A novel quantitative detection method of corrosion product thickness using X-ray and digital image processing techniques is proposed for investigating the continuous development of corrosion products. As the corrosion level increases, a smaller steel-to-rust volume expansion ratio caused by continuous leakage and a lower oxidation degree of corrosion products for the GS specimens are the major reasons for the smaller corrosion cracks. Regarding the effect of rebar arrangement on the development of corrosion-induced cracks, the expansion stress from corner-located rebars restrained the growth of corrosion products and further limited the propagation of corrosion-induced cracks of the center rebar. Estimated corrosion crack width via FE analysis using measured corrosion products as input show good agreement with experimental results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callSimilar Papers
More From: Cement and Concrete Composites
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
