Abstract
This paper presents a developed beam-to-column connection which is suitable for weak axis of I-section column and H-shaped beam. Ten cruciform joint specimens, including five bare steel joint specimens (SJ) and five composite joint specimens (CJ) reinforced with partial shear connection, were tested under reversal of loads to evaluate the effect of composite action on the developed weak-axis connections. The beam ends were designed with standard, RBS, cover-plate, taper flange, and welded haunch respectively. The experimental results are analyzed and the composite action is discussed based on the test data. Overall, most joints failed due to welding fracture at the conjunction of diaphragm, skin plate and beam-end flange. But relatively speaking, the composite specimens performed well and achieved the story drift ratios of 0.04rad before experiencing 20% strength degradation because only slight strength degradation occurred in the composite joints compared to bare steel joints, thus the composite joints have a more stable bearing capacity. The test data clearly illustrate that the neutral axis shifted upward significantly under positive bending, resulting in larger strains on beam bottom flange. The reinforcing bars in concrete slab did not work well, but remained in elastic state. The slab slippage was negligible even in 50% degree partial shear connection. The welding quality is an important guarantee to avoid the brittle failure of the connections, and lamellar tearing resistant steel is suggested to be used in skin plate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.