Abstract
Underwater wet flux-cored arc welding (FCAW) process was used to join 2205 duplex stainless steel using Ni-based filler under three different heat inputs of 16.9 kJ/cm, 23.5 kJ/cm and 32 kJ/cm. The arc stability, microstructure and corrosion resistance with different heat inputs were studied. The results showed that the welding process at the heat input of 23.5 kJ/cm was stable with less spatter and good weld appearance. The weld width, weld penetration and dilution ratio increased with increasing heat input. A single-phase austenitic microstructure was obtained for all welds with varied parameters. The heat-affected zone consisted of coarse ferrite and austenite in grain boundary. The grain size of weld zone and heat-affected zone coarsened as the heat input rose. Compared with the base 2205 base metal, the hardness of HAZ increased about 15% while the weld metal changed little. Electrochemical test in 3.5% NaCl solution indicated that the corrosion resistance of the weld metal under high heat input was better, but its corrosion resistance was inferior to that of base materials. Weld metal obtained at 23.5 kJ/cm possessed comprehensive properties in terms of arc stability and corrosion resistance. These results are helpful to promote the application of duplex stainless steel in the fields of nuclear power fields.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
