Abstract
Objective. In this work, we present and evaluate a technique for performing interface measurements of beta particle-emitting radiopharmaceutical therapy agents in solution. Approach. Unlaminated EBT3 film was calibrated for absorbed dose to water using a NIST matched x-ray beam. Custom acrylic source phantoms were constructed and placed above interfaces comprised of bone, lung, and water-equivalent materials. The film was placed perpendicular to these interfaces and measurements for absorbed dose to water using solutions of 90Y and 177Lu were performed and compared to Monte Carlo absorbed dose to water estimates simulated with EGSnrc. Surface and depth dose profile measurements were also performed. Main results. Surface absorbed dose to water measurements agreed with predicted results within 3.6% for 177Lu and 2.2% for 90Y. The agreement between predicted and measured absorbed dose to water was better for 90Y than 177Lu for depth dose and interface profiles. In general, agreement within k = 1 uncertainty bounds was observed for both radionuclides and all interfaces. An exception to this was found for the bone-to-water interface for 177Lu due to the increased sensitivity of the measurements to imperfections in the material surfaces. Significance. This work demonstrates the feasibility and limitations of using radiochromic film for performing absorbed dose to water measurements on beta particle-emitting radiopharmaceutical therapy agents across material interfaces.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have