Abstract
Understanding the fracture mechanism is essential for optimizing the mechanical properties of titanium alloys. The relationship between fracture behaviour and the multistage lamellar microstructure of the TC18 (Ti–5Al–5Mo–5V–1Cr–1Fe) alloy was investigated via in situ tensile and three-point bending tests. The results indicate that the TC18 alloy, featuring a multistage lamellar microstructure (including a β matrix, primary lamellar α phase, bundles, and secondary lamellar α phase), exhibits an excellent combination of strength and ductility. The precipitation of the secondary lamellar α phase significantly enhances the alloy's strength but weakens the stress‒strain compatibility of the microstructure. This results in a smaller crack-tip plastic zone (CTPZ) and causes dislocations to concentrate more at the grain boundaries and, to a lesser extent, at the phase interfaces. Consequently, in the later stages of crack propagation, microvoids and microcracks tend to form at dislocation pile-ups. With increasing stress, these microvoids and microcracks rapidly coalesce, leading to a greater proportion of intergranular fracture and thus reducing the fracture toughness of the alloy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Progress in Natural Science: Materials International
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.