Abstract
In the present study, four materials, nickel, tantalum, EN58B and titanium are examined, and information about the drilling speed is obtained. A statistical analysis of the results for drilling speed is undertaken, and the significance of each factor examined is determined. It is found that to obtain good holes it is not merely a matter of optimizing the surface power intensity, but adjusting all factors so that the process of transferring energy into the workpiece produces the desired effects.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.