Abstract
There are many reports on fundamental experiment of "Nylon-Steel" abrasion. But these are a little used for actual gear. This report discusses a nylon gear meshing with a hobbed steel gear and a ground steel gear. The load test of nylon cylinder was performed using a steel cylinder which has a different surface finishing. The abrasion, the allowable limit load, the surface temperature, the modes of breakage of nylon cylinder owing to a difference of a surface finishing of steel cylinder were investigated and useful data for design of nylon gear were collected.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
