Abstract
This study conducted on-site measurements of air temperature and airflow velocity at the cold aisle outlet, combined with infrared imaging, to derive optimized layouts for rack servers. It was found that installing blind plates effectively improves the uniformity of cold air distribution within the racks, as indicated by the temperature and airflow velocity at the server inlet and outlet under both blind and non-blind plate conditions. Finally, thermal performance indicators (i.e., SHI, β, RHI, RCI) and Reynolds number were used to assess the thermal performance of the data center, while energy efficiency indicators (i.e., PUE, WUE, CUE) were employed to evaluate its energy efficiency. The results revealed that the cold aisle has less air distribution at both ends and is more concentrated in the middle. It is advisable to position high-power servers in the middle racks and place racks with relatively lower power at the front and rear ends to ensure effective heat dissipation of the servers. The installation of blind plates can effectively enhance the uniformity of airflow within the racks and improve server cooling. Among the tested racks, 16 out of 17 exhibited low temperatures (RCILO) below 90%, indicating heat loss and energy waste. The PUE value of the data center is 1.19, and the CUE value is 0.77.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.