Abstract
Bulk niobium is currently the material of choice for superconducting radio frequency (SRF) cavities and is a well matured process. However, it is possible that SRF cavities could be further improved beyond bulk Nb by sputtering thin Nb films onto Cu cavities. Copper has a greater thermal conductivity than Nb and is also easier to machine, whilst sputtering films on the surface reduces the amount of Nb used to fabricate the whole cavity. However, sputtering Nb on Cu produces other issues, for example, the surface quality of the Cu affects the quality of the Nb deposited on the surface and therefore the superconducting parameters. As the Nb on the surface is not perfect, the magnetic field produced by the RF can enter the cavity earlier than expected, producing RF losses, which can in turn lead to a quench. One approach is to treat the Nb post deposition by irradiating the surface using a laser to polish the surface of the Nb and increase the surface magnetic field that the cavity can maintain whilst remaining in the Meissner state. A magnetic field penetration experiment designed and built at Daresbury Laboratory has been used to measure the field of full flux penetration to characterise the effect of the laser treatment on the superconducting properties of the Nb. Surface characterisation and the response of the Nb in a DC magnetic field have also been performed to try and provide an explanation for the change in the superconducting properties. The results demonstrate that the laser treatment can lead to an increase in the magnetic field at which the flux penetrates from one side of the sample to the other, thus it could potentially improve the performance of Nb coated RF cavities.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have