Investigating the laser metal deposition of Inconel 718 superalloy using the numerical and experimental methods

Abstract

In this research, a volume of fluid (VOF) model was developed to investigate the effect of laser deposition parameters on the geometry of molten pool and deposited layer in the Inconel 718 superalloy. For this purpose, the process parameters of laser power, laser beam diameter and scanning speed were considered to estimate the geometric characteristics of the molten pool and deposited layer. In the following, the laser deposition process of Inconel 718 superalloy was carried out experimentally to validate the results of simulation. It was observed that an increase in the laser power from 100 to 400 W resulted in an improvement in the length, width and depth of molten pool, while an increase in the values of laser beam diameter (from 1 to 2 mm) and scanning speed (from 2 to 10 mm s−1) was associated with a reduction in the length, width and depth of molten pool. From the results of both simulation and experiments, a reduction was observed in the wetting angle of deposited layer when the values of laser power and scanning speed increased up to 400 W and 10 mm s−1 respectively, while the increase of feeding rate from 48 to 62 mgr s−1 indicated an improvement in the wetting angle. It was also observed that the maximum penetration depth was obtained in the rear part of molten pool due to Marangoni convection currents that pushed the melt toward the end of molten pool. The comparison of the experimental results and those predicted by the VOF model indicated that the model is capable of predicting the shape of deposition layer with sensible error.