Investigating the influences of the geometry and orientation of corrugation in the steel shear walls on the cyclic behavior through the use of finite element analysis

Abstract

To dampen the loading sequences in the constructions, using the shear walls is recommended. Shear walls, which withstand the lateral forces (i.e., parallel to the plane of the wall) of wind and seismic activity, prevent buildings from collapsing while columns and load-bearing walls support the structure’s compression load all the way to the foundation. Besides, some new techniques are innovated for strengthening the structure like outrigger system. The steel shear walls are mostly used in the steel structures due to their high strength, ductility, and low weight. Recently, implementing Corrugated Steel Shear Walls (CSSWs) has gained more attention because they can absorb much amount of energy compared to flat steel shear walls. There are two important parameters in the CSSWs that play crucial roles in controlling their strength; corrugation geometry and orientation. Therefore, the current research paper aims to study numerically the effects of four corrugation geometries (trapezoidal, square, zigzag, and curved) with two orientations on the cyclic behavior of the CSSWs. Finite Element Analysis (FEA) is used to simulate the seismic loading conditions and finally, this procedure is validated through the comparison of the modeled flat shear wall with the experimentally published results. The difference between the peak loads of hysteresis curves obtained numerically and experimentally is about 8.5%. The stated FEA procedure in this paper can be regenerated by other researchers. The results confirmed the applicability of the CSSWs compared to the flat shear walls. Also, the vertical corrugation infill patterns result in higher strength in comparison to the horizontal ones. For instance, in the zigzag and square corrugation shapes, the plastic energy dissipation of the vertically oriented specimens (13.84 and 14.01 KJ, respectively) is higher around 7% and 29%, respectively than the horizontally oriented ones (12.9 and 10.84 KJ, respectively). Besides, the trapezoidal and curved corrugation geometries show the highest cumulated energy and plastic energy dissipation.