Abstract
Heavy oil is one of the most useful energy resource special in the times of crises when other resources are not present in profusion. However, Occurrence of heavy oil in unconsolidated sands is one the most challenging factor to recover the heavy oil. Therefore, in this study the main focus is derived towards the extraction of heavy oil with optimistic procedure called air injection. For the research, a reactor assembly was developed for the experimental work on air (21% oxygen) injection into heavy oil (12.59 °API) reservoir. Total 13 kinetics runs were conducted on unconsolidated cores by varying the parameters involved system pressure, flow rate (air flux), oxidation temperature (heat input), and rock formation (sand matrix). It was found that the process is very dependent on operating conditions employed, as oxygen consumption rate was very dependent on air flux. Increase of air flux from 15.19 to 22.78 m 3 /m 2 -hr resulted in slightly increasing rates of oxygen consumption over the temperature range under investigation. The temperature difference also shows great effect on the high temperature oxidation. The pressure and porous media also has great impact on the combustion behavior. The influence of individual parameter was obtained from analysis of the inlet oxygen and composition of flue gases from the combustion cell. Indeed, the oxygen conversion was too less to evaluate the kinetic data at temperature less than 250 °C while for oxidation reactions, the oxygen statistics analyzed from temperature above than 350 °C. The experimental results reveal that the average maximum peak temperature was 440 °C, and the oxidation reaction process at high temperature was very effective in terms of produced carbon oxides with an average percentage of 9.5% CO 2 , 5.5% CO in flue gases. Oil displacement was observed from the analysis of flue gases, consequently; incremental oil recovery was achieved between 56%-80% under high temperature oxidation (HTO) conditions.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
