Investigating the impact of thermal treatment on fracture toughness and sub-critical crack growth parameters under mode II loading

Abstract

Studying subcritical crack growth is crucial to investigating the long-term behavior of rocks under applied loads and evaluating the long-term stability of underground and surface structures in rock masses. While considerable research has been done to determine subcritical crack growth parameters in mode I, Studies on subcritical crack growth under mode II loading are limited despite its important applications in rock engineering problems. The purpose of the study is to understand the thermal effect on the fracture behavior of hornfels rock, which were heated at 25 °C (without thermal treatment), 250 °C, 500 °C, and 750 °C, respectively. The subcritical crack growth parameters were determined using the constant stress rate test and one of the available fracture mechanics tests for mode II loading, namely, the four-point bending test. Experiments were conducted at three fixed displacement rates of 0.06 mm/min, 0.6 mm/min, and 6 mm/min, and three experiments were performed in each case to ensure repeatability. The results showed that the fracture toughness of hornfels samples increased with increasing temperature up to 250 °C and then decreased with increasing heat treatment temperature. The fracture toughness decreased drastically due to the thermal breakdown of the quartz crystal structure and the creation of wider intergranular fractures. The study indicated that for the hornfels samples, the subcritical parameter A decreased and beyond this temperature, parameter A began to increase while parameter n remained relatively constant as the temperature rose to 750 °C. The subcritical crack growth rate was calculated using the subcritical crack growth parameters and the stress intensity factor under mode II loading. For a certain value of the stress intensity factor KII, the highest subcritical crack velocity occurred at the temperature of 750 °C (5.76×10−7–2.47×10−1 m/s), and the lowest velocity of the subcritical crack occurred at the temperature of 250 °C (3.30×10−11–6.84×10−5 m/s). The impact of inert strength, calculated at the highest loading rate, on subcritical parameters across various temperatures was examined. The findings indicate that the subcritical crack growth parameter A is reliant on inert strength.