Investigating the impact of different solder alloy materials during laser soldering process

Abstract

PurposeThis study aims to investigate the influence of different solder alloy materials on passive devices during laser soldering process. Solder alloy material has been found to significantly influence the solder joint’s quality, such as void formation that can lead to cracks, filling time that affects productivity and fillet shape that determines the solder joint’s reliability.Design/methodology/approachFinite volume method (FVM)-based simulation that was validated using real laser soldering experiment is used to evaluate the effect of various solder alloy materials, including SAC305, SAC387, SAC396 and SAC405 in laser soldering. These solders are commonly used to assemble the pin-through hole (PTH) capacitor onto the printed circuit board.FindingsThe simulation results show how the void ratio, filling time and flow characteristics of different solder alloy materials affect the quality of the solder joint. The optimal solder alloy is SAC396 due to its low void ratio of 1.95%, fastest filling time (1.3 s) to fill a 98% PTH barrel and excellent flow characteristics. The results give the ideal setting for the parameters that can increase the effectiveness of the laser soldering process, which include reducing filling time from 2.2 s to less than 1.5 s while maintaining a high-quality solder joint with a void ratio of less than 2%. Industries that emphasize reliable soldering and effective joint formation gain the advantage of minimal occurrence of void formation, quick filling time and exceptional flowability offered by this solution.Practical implicationsThis research is expected not only to improve solder joint reliability but also to drive advancements in laser soldering technology, supporting the development of efficient and reliable microelectronics assembly processes for future electronic devices. The optimized laser soldering material will enable the production of superior passive devices, meeting the growing demands of the electronics market for smaller, high-performance electronic products.Originality/valueThe comparison of different solder alloy materials for PTH capacitor assembly during the laser soldering process has not been reported to date. Additionally, volume of fluid numerical analysis of the quality and reliability of different solder alloy joints has never been conducted on real PTH capacitor assemblies.