Investigating the effect of raster orientation on fracture behavior of 3D-printed ABS specimens under tension-tear loading

Abstract

Most of the engineering components are servicing under complex loading conditions or have complex geometries that lead to a multiaxial stress state in the component. Thus, the fracture behavior of parts under mixed-mode loading conditions should be investigated. The Fused Deposition Modeling (FDM) is a subcategory of the Additive Manufacturing (AM) techniques that has some important manufacturing parameters. The raster orientation (or raster angle) is one of fabricating parameters that significantly affect the mechanical behavior of fabricated parts. Therefore, this study aims to investigate the fracture behavior of FDM specimens made of Acrylonitrile Butadiene Styrene (ABS) under mixed-mode I/III loading conditions. To this goal, four different raster configurations of ψR = 0/90°, 15/-75°, 30/-60°, and 45/-45° were selected for FDM fabrication of edge cracked rectangular specimens, and five loading angles of β = 0° (mode I), 40°, 65°, 72°, and 90° (mode III) were used for performing mixed-mode I/III fracture experiments on the pre-cracked specimens. Besides, some tensile experiments were performed on dog-bone specimens fabricated with the mentioned raster configurations. In order to theoretically predict the failure loads in the tested cracked specimens, a theoretical model named Equivalent Material Concept (EMC) was utilized for equating the ductile behavior of FDM-ABS material with a brittle one. The mentioned concept was coupled with J-integral (EMC-J) and Maximum Tangential Stress (EMC-MTS) criteria to predict the failure loads under mixed-mode loading conditions. The results showed that both EMC-J and EMC-MTS criteria could predict the experimental failure loads well. Additionally, Scanning Electron Microscopy (SEM) was performed on the fracture surfaces to analyze the failure mechanisms of the tested specimens. SEM analysis confirmed the presence of three failure features namely air gaps, filament pullouts, and hackle regions that were discussed comprehensively.