Abstract

We present elemental and isotopic data detailing how the Mg isotope system behaves in natural and experimentally synthesized clay minerals. We show that the bulk Mg isotopic composition (δ26Mg) of a set of natural illite, montmorillonite and kaolinite spans a 2‰ range, and that their isotopic composition depends strongly on a balance between the relative proportions of structural and exchangeable Mg. After acid leaching, these natural clays become relatively enriched in isotopically heavy Mg by between 0.2‰ and 1.6‰. Results of exchange experiments indicate that the Mg that has adsorbed to interlayer spaces and surface charged sites is relatively enriched in isotopically light Mg compared to the residual clay. The isotopic composition of this exchangeable Mg (−1.49‰ to −2.03‰) is characteristic of the isotopic composition of Mg found in many natural waters. Further experiments with an isotopically characterized MgCl2 solution shows that the clay minerals adsorb this exchangeable Mg with little or no isotopic fractionation, although we cannot discount the possibility that the uptake of exchangeable Mg does so with a slight preference for 24Mg. To characterize the behaviour of Mg isotopes during clay mineral formation we synthesized brucite (Mg(OH)2), which we consider to be a good analogue for the incorporation of Mg into the octahedral sheet of Mg-rich clay minerals or into the brucitic layer of clays such as chlorite. In our experiment the brucite mineral becomes enriched in the heavy isotopes of Mg while the corresponding solution is always relatively enriched in isotopically light Mg. The system reaches a steady state after 10days with a final fractionation factor (αsolid-solution) of 1.0005 at near-neutral pH. This result is consistent with the general consensus that secondary clay minerals preferentially take up isotopically heavy Mg during their formation. However our results also show that exchangeable Mg is an important component within bulk clay minerals and can have an important influence over the bulk clay δ26Mg value. Modeling shows that in certain soils or sediments where the percentage of exchangeable Mg is >30% and the isotopic composition of the exchangeable Mg is around −2‰, the generation of bulk δ26Mg values of <−0.5‰ is likely. On a broader scale, Mg-rich minerals such as smectite and illite are likely to impart a stronger control over the Mg budget in clay rich sediments, and their high structural Mg component is likely to result in bulk sediment δ26Mg values that are closer in composition to the UCC. Despite this, results of modeling, together with experimental observation suggests that the uptake of exchangeable Mg into these clay rich sediments could cause a decrease in the bulk δ26Mg value by up to ∼0.3–0.4‰. This should be accounted for when assessing the δ26Mg value of sediments on a crustal scale.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call