Abstract

This paper investigates the impact on operating time delay and relay maloperation i.e. selectivity, when high sampling rate is used in numerical distance protection (NDP). Simulation is carried out in an on-line way, for different source to line reach impedance ratio (SIR), fault type, fault locations and for different loading conditions. The voltage and current signals from capacitive voltage transformers and current transformers respectively are fed to the numerical distance relay (NDR). Sampling rate of 12, 16, 24, 32 and 64 times the fundamental frequency (50 Hz) are chosen for this investigation, since these are typically used in conventional distance relays.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.