Investigating maximum temperature lift potential of the adsorption heat transformer cycle using IUPAC classified isotherms

Abstract

Adsorption heat transformer (AHT) cycle is capable of upgrading the low-grade waste heat to a higher temperature. The maximum temperature lift of the AHT cycle can represent its theoretical performance limit. However, such a metric is currently absent from the literature due to the scarcity of fundamental studies on the heat upgrading sorption cycles. Therefore, in the present study, three models are proposed to derive the ‘maximum temperature lift’ of a typical AHT cycle: (i) heat engine heat pump representation, (ii) the 2nd law of thermodynamic formulation, and (iii) complete preheating. The first two models are developed based on the reversible cycle approach, whereas the 3rd model incorporates adsorbed phase properties. Thus, the first two models might be considered as the formulations for the thermodynamic temperature limit (lift) of an AHT cycle while the 3rd model is specific to the nature of a particular adsorbent + adsorbate pair which might be close to practical applications. The reversible models predict a maximum temperature lift of 22∘C to 58∘C for heat source temperatures between 50∘C to 80∘C. The 3rd model exhibits lower values of maximum temperature lift compared to the reversible models, owing to the inclusion of material properties in its formulation. The performance of the models is demonstrated by determining the maximum temperature lift of four water-based adsorption working pairs, each featuring distinct IUPAC (International Union of Pure and Applied Chemistry) isotherm types. This study will help propel the working pair selection and the thermodynamic modeling of sorption cycles to achieve its near maximum capability.