Abstract
The contribution of distributed generation (DG) to network fault levels depends heavily on the technology employed. In the case of directly connected rotating machines the fault behavior is well established; with synchronous generators contributing higher fault levels than the corresponding induction generators. The contribution of inverter-based distributed generation (IBDG) is the lowest due the capability of this technology to exhibit non over-load characteristics. However the behavior of this generation technology under fault conditions is determined by the employed control methods. In this paper, an investigation of the effect of the DG type on the fault current is investigated. Simulations for case studies have been conducted using Matlab/Simulink.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.