Abstract
The new inversion algorithm developed based on the recent progress in the nonlinear programming study by us is used to invert the earthquake source process of Chi Chi earthquake M w 7.6, 20 Semptember,1999, Taiwan. A curve fault model is constructed in our inversion to make the fault model close to the real rupturing fault to reduce the influence from the discrepancy between the constructed fault model and the real rupturing fault. The results show that (1) the rupture process of the Chi Chi earthquake source lasted about 32 seconds and the main faulting occurred between 6th to 21st second after the start of the ruptures and the high slip area were mainly located at the northern segment of the fault. (2) The slip was dominated by thrust faulting. The average rake angle was 64.5°, which was very consistent with those inverted by USGS, Harvard and CWB (Central Weather Bureau of Taiwan). The amount of the moment inverted in this paper was 7.76×10 20 NM, which was a slightly bigger than those inverted by USGS and Harvard. (3) A clear nucleation step existed in the source faulting process and it lasted about 6 seconds. The moment release rate accelerated obviously at the end of the nucleation step. The faulting started from the southern segment and mainly occurred at the northern segment after 10 seconds. At the end of this paper, we analyzed the reliability of the inversion result via comparing with the GPS observations and discussed its scientific signification.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.