Abstract
Abstract An investigation is performed concerning the applicability of inverse procedures, using optimization and simple experiments, for characterization of WC/Co powder materials. The numerical procedure is combined with uniaxial die-compaction experiments using an instrumented die, which allows direct measurement of the distribution of radial stress during the experiments. Finite-element (FE) methods and an advanced constitutive description of powder materials are relied upon to model the compaction experiment. Optimization using a surrogate model is used to determine some of the parameters in the constitutive description. These parameters in the material model are said to be found (with some accuracy) if the output from the FE simulation is similar to the experimental data. It is found that even though a complete constitutive description of the powder materials investigated cannot be achieved using this approach, many important material parameters can be determined with good accuracy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.