Abstract
In this work, microspeaker frequency response was determined based on measurement and simulation. The vents after the rear chamber of the microspeaker were covered with ventilation cloths. Two types of ventilation cloths (acoustic cloths) are commonly used in electroacoustic products, non-woven and woven. Non-woven cloths (5 nos.) consist of irregular meshes and woven cloths (5 nos.) consist of regular meshes. The equivalent circuit model of the microspeaker was formulated by considering five types each of non-woven and woven ventilation cloths. The acoustic properties of the ventilation cloths were estimated from the measured frequency response of the microspeaker and by subsequent use of particle swarm optimization algorithm. Estimated value of the acoustic impedances of the ventilation cloths were used in an equivalent circuit model of the microspeaker for the simulated frequency responses and subsequently compared with the anechoic chamber measurements. Based on the results, the equivalent circuit adequately simulated the measured frequency response of the microspeaker and the estimations of the acoustic impedances of the ventilation cloths were in good agreement with the measured frequency responses of the microspeaker.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have