Abstract
AbstractA new inverse design process for horizontal axis wind turbine blades is developed to account for three‐dimensional blade features such as non‐planar wing tip. The multidimensional Newton iteration method combined with a vortex line method is used to provide blade geometry parameters given desired aerodynamic behaviors such as lift coefficient and axial induction. The Jacobian matrix is visualized to show the effect of the change of the blade twist and chord on the change of the aerodynamic behaviors. The method is validated for a canonical straight blade with uniform lift coefficient and axial induction distributions. The results show an excellent agreement with those obtained by PROPID, which is a blade element momentum theory‐based inverse design code. The National Renewable Energy Laboratory Phase VI blade is used to validate the method for a straight blade with non‐uniform distributions of the lift coefficient and axial induction. The method is also applied successfully to a non‐straight blade design with a non‐planar wing tip. A noticeable change in the twist and chord for this non‐straight blade is seen compared with a straight blade. Finally, the inverse design code is used to make a large rotor blade, and the power output generated by this blade is computed. Copyright © 2014 John Wiley & Sons, Ltd.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.