Abstract
The study was aim to determine the suitability of intersecting gilling machine in jute processing system. In this regard the machine was used for processing of jute fibre to yarn [1]. The third drawing sliver passed through the intersecting gilling of GN5 type into 4:1 input –output ratio of slivers. Yarns spun by this slivers through different types of spinning frame. Quality ratio of jute yarns produced from different spinning machines were measured. These were for Hessian Spinning machine is 84.17%, Apron draft spinning frame is 88.59% and Spingard spinning frame 96.34%. However for medium count jute-polypropylene blended yarn, the quality ratios are between 102- 112 and yarns were spun by hessian spinning frame. These results compared with the yarn produced through conventional jute spinning system (except intersecting Gilling machine, table 2). Findings of the study indicate a new era for the jute processing by using intersecting Gilling machine. It is observed that the introduction of Intersecting Gilling machine has a potential prospect in jute processing for making fine jute yarn. Keywords: Intersecting gilling; drawing machines; spinning machines; jute yarn. DOI: http://dx.doi.org/10.3329/diujst.v6i2.9347 DIUJST 2011; 6(2): 63-66
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Daffodil International University Journal of Science and Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
