Intrinsic viscosity, rheological property, and oil displacement of hydrophobically associating fluorinated polyacrylamide

Abstract

ABSTRACTThe surface‐active polymer (FPAM) was synthesized by free‐radical polymerization of acrylamide (AM), 2‐acrylamido‐2‐methyl‐1‐propane sulfonic acid (AMPS) and N‐dodecyl‐N‐perfluoro octane sulfonyl acrylamide (AMPD), which was prior prepared by reacting dodecylamine, perfluoro‐1‐octanesulfonyl fluoride, and acryloyl chloride. Parameters affecting the intrinsic viscosity ([η]) and apparent viscosity (η) of FPAM, such as reaction temperature, AMPD concentration, AMPS concentration, monomer concentration, initiator concentration, and pH were examined. Apparent viscosity and interfacial tension (IFT) of FPAM solution were evaluated. Subsequently, temperature tolerance and shear tolerance were investigated by comparing with hydrolyzed polyacrylamide (HPAM), and results indicated that the FPAM displayed better performances than HPAM. FPAM can reduce the IFT between crude oil/water, and the IFT values are around at 2.91 and 3.9 mN m−1 corresponding to FPAM and HPAM/FC‐118. The sandpack model oil displacement experiment showed that water flooding can further increase the oil recovery to 15.01% (FPAM), compared with 9.26% oil recovery for HPAM, and 10.99% oil recovery for HPAM/FC‐118. The glass micromodel techniques for studying enhanced oil recovery get a good result and provide a useful reference for understanding the displacement behaviors in polymer flood process. It could be concluded that the introduction of fluorinated groups in the polymer chain was helpful in enhancing the oil displacement efficiency. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2017, 134, 44672.