Intraoperative Computed Tomography for Repair of Facial Fractures

Abstract

Objective: To assess the practicality and potential benefitsofintraoperativecomputedtomographyusingamobile scanner in the operating room during repair of orbitozygomatic fractures. Setting: Level I trauma center. Design: Twenty-five patients undergoing open reductionofaunilateraldisplacedfractureofthezygomaand/or repairofablow-outfractureoftheorbitwithcranialbone grafts were placed into a radiolucent head holder and interfaced with the mobile scanner. Spatial vectors were drawn on scans displayed on a computer monitor to allow intraoperative side-to-side comparison of the position of the malar prominences and orbital walls. Corrections of fracture reduction or bone graft position were made as indicated by the comparisons. Results: All scans were accomplished without apparent contamination of the surgical field. Major revisions were performed, based on the scans, in 2 patients whose displaced, comminuted zygoma fractures had been initially reduced with wide exposure of all fracture sites. Minor revisions were performed in 3 patients with displaced but less severely comminuted fractures that had been reduced without exposure of all fracture sites. Bone grafts were repositioned within the orbit in 2 patients with large 2-wall blow-out fractures. Conclusions: Intraoperative computed tomographic evaluation of the adequacy of repair of orbitozygomatic fractures is feasible with the mobile computed tomographic scanner. The scanner allows correction of discrepancies in position of the malar prominences and orbital walls at the time of acute repair, rather than during costly, more difficult delayed revisions. It may eliminate the need for direct visualization of all fracture sites to ensure adequate reduction in selected cases with displaced, comminuted fractures, thus decreasing operating room time and expense. Further study is required to fully document the cost-effectiveness of this approach to facial fracture management.