Intracoronary stent implantation using a single high-pressure perfusion balloon catheter.

Abstract

Currently, the recommended strategy for Palmaz-Schatz intracoronary stent implantation is to use two balloons: an undersized balloon for predilation to facilitate a channel for the stent and a high pressure balloon for postdilation to obtain good apposition of the struts into the vessel wall. We reported our experience using the perfusion balloon as the initial balloon to dilate intracoronary lesions and demonstrated a reduction in the total number of balloons used per angioplasty procedure. The objective of this study was to examine whether a single balloon could effectively be used for stent implantation. The study population included 95 patients who underwent elective intracoronary stent placement to 100 lesions using 110 Palmaz-Schatz stents by nine individual operators. Lesions were predilated with an ACS RX LIFESTREAM balloon at a low pressure of 4-6 atm (mean 5.7 +/- 2.6). After stent deployment, the same balloon was used at a high pressure (mean 16.2 +/- 1.2). Mean balloon size, which was chosen as the stent size, was 3.4 +/- 0.4 mm. Comparison of this strategy with the recommended strategy of 68 consecutive elective stent deployments at a single center during the same time was performed. Stent implantation using a single balloon strategy was angiographically successful in 99 of 100 (99.0%) lesions. The single balloon strategy was associated with a balloon burst rate of 9.1%. The number of balloons used per stent deployment was 1.2 vs. 2.4 using the recommended strategy (P < 0.0001). There was no evidence of stent thrombosis, any MI, or target lesion revascularization during the procedure and hospitalization. One in-hospital death as a result of nonhemorrhagic stroke was documented in the treated group. We concluded that using a single high pressure perfusion balloon for pre and postdilation in patients undergoing elective stent placement is safe and reduces the number of balloons used per procedure.