Intra-individual comparison of lumbar spine CT, abdomen-pelvis contrast enhanced CT, and low-dose chest CT for bone density measurement.

Abstract

Dual-energy X-ray absorptiometry (DXA) is the reference standard for the measurement of bone mineral density (BMD) and subsequent diagnosis of osteoporosis. Since various computed tomography (CT) protocols are scanned for various indications, we can incidentally measure BMD using CT. Previous studies have revealed a correlation between BMD and Hounsfield unit (HU) values obtained with different CT protocols. To compare the diagnostic value of CT protocols (lumbar spine CT [LSCT], abdomen-pelvis contrast-enhanced CT [APCT], and low-dose chest CT [LDCT]) for osteoporosis. We retrospectively included 17 patients (6 men, 11 women; mean age=68 years) who had undergone all four imaging studies within six months, during 2011-2021. HU values were manually measured at the center of the L1 vertebra by a radiology resident. Pearson correlation test was performed between HU values and BMD of L1 vertebra. The diagnostic performance of each CT protocol was assessed with receiver operating characteristic (ROC) analysis. Intra-individual concordance of the four tests to diagnose osteoporosis was analyzed by tabulating. The mean HU values were 104.4 ± 47.2 HU with LSCT, 149.0 ± 56.9 HU with APCT, and 114.3 ± 60.0 HU with LDCT. HU values from each protocol were positively correlated (r = 0.676-0.735; P < 0.005) with BMD. LDCT had the highest diagnostic performance (area under the ROC curve [AUC] = 0.701) and APCT the lowest (AUC = 0.569). APCT was discordant with the other protocols for diagnosing osteoporosis. LDCT had the highest diagnostic performance for osteoporosis with predetermined cutoff value. APCT requires the increase of cutoff value for osteoporosis diagnosis.