Abstract
Gloss meters are commonly used to measure characteristics of the specular light reflected from materials. Such meters are based on illumination and detection at equal, opposite angles. The particular angle, , and other parameters of instrument geometry, are well known to play major roles in the results produced by a given meter, so several standards have been developed for gloss measurements that specify the geometry and optical characteristics of gloss meters (TAPPI T480; ISO-2813 (1994); ASTM-D523-89 (1999)). Nevertheless, the reason why gloss meter readings change with , and the reasons why meters of the same  produce different readings seem not to be well understood. The focus of the study described in this paper has been on exploring these two effects. A quantitatively model of a generic gloss meter was constructed from Fresnel's law of surface reflection combined with empirical models of bidirectional reflectance distribution function (BRDF). Comparison of the model with experimental data strongly indicates that the width of the BRDF, and therefore the roughness of the surface, plays the major role in governing the reading from a gloss meter. Differences in index of refraction, by comparison, appear to play only a minor role. In addition, differences in gloss readings produced by instruments of the same angle, , were found to be the result of differences in the instrument angles of acceptance. The results of these studies suggest that it may be possible to make better use of conventional gloss meter measurements by making measurements at multiple angles, , rather than just a single angle.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have