Abstract
AbstractResidual stress measurements and distortion analyses have been conducted on injection molded plaques made from polypropylene (PP) and a short glass‐fiber filled polypropylene (GFPP). The residual stress analyses include measurements both parallel and perpendicular to the direction of flow during mold filling. Residual stresses are very anisotropic in GFPP, but not in PP. The residual stress levels in PP fall on aging at room temperature, whereas in GFPP the proportion of stress relaxation is smaller, and significant stresses remain even after heating to elevated temperatures. A significant contribution to distortion has been linked to the ejection process, and the long‐ and short‐term distortion of moldings is discussed within the framework of the properties of the materials measured here.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.