Internal exhaust gas recirculation via reinduction and negative valve overlap for fuel-efficient aftertreatment thermal management at curb idle in a diesel engine

Abstract

Low air-flow diesel engine strategies are advantageous during low load operation to maintain temperatures of a warmed-up aftertreatment system (ATS) while reducing fuel consumption and engine-out emissions. This paper presents results at curb idle for internal EGR (iEGR) that demonstrate low airflow and reduced engine-out emissions during fuel-efficient ATS temperature maintenance operation. Internal EGR via reinduction and trapping using negative valve overlap (NVO) are compared to each other, conventional operation and to other low airflow approaches including cylinder deactivation (CDA). At 800 RPM/1.3 bar BMEP (curb idle) iEGR via reinduction enables 200°C engine-out temperature combined with 70% lower NO X, 35% lower fuel consumption, and 40% lower exhaust flow rate than conventional thermal management operation. Internal EGR via trapping using NVO resulted in an engine-out temperature of 185°C, with 56% lower NO X and 25% lower fuel consumption than conventional thermal management operation. Both iEGR strategies have lower engine-out temperatures and higher exhaust flow rates than CDA. No external EGR is required for either iEGR strategy. “iEGR via reinduction” outperforms “iEGR via NVO” as a result of higher open cycle efficiency (via less pumping work) and higher closed-cycle efficiency (via higher specific heat ratio).