Intermetallic morphology around Ni particles in Sn‐3.5Ag solder

Abstract

The influence of the thermal reflow profile on the formation and resultant morphology of the intermetallic layer that developed at the Ni particle reinforcements within an eutectic Sn‐Ag composite solder matrix was investigated. The composite solder was fabricated by mechanically dispersing 15 vol% Ni particles into eutectic Sn‐3.5Ag solder paste. Two distinct intermetallic compound (IMC) morphological microstructures were observed around the Ni reinforcements. IMC morphological microstructure apparently varied depending on the amount of heat input and differences in heating rates used in the reflow profile. A “sunflower” IMC morphology was typically noted when the total amount of heat input was small. However, with sufficient heat input, a faceted “blocky” IMC morphology was consistently achieved. Multiple‐reflow thermal profiling experiments were conducted to measure and compare the amount of heat input necessary to change the sunflower IMC morphology around Ni particle reinforcements to the blocky morphology.