Interlaboratory study of flexural strength in additively manufactured alumina

Abstract

AbstractWe report the results of an international interlaboratory study of the flexural strength of alumina fabricated across six laboratories using the vat photopolymerization ceramic additive manufacturing (AM) technology. The mechanical testing of all the specimens, 142 in total, was performed at the National Institute of Standards and Technology (NIST) according to the well‐established four‐point bending method standardized for traditional ceramics. Overall, the existing ASTM standard for the four‐point bend testing proved adequate for AM ceramics, with several modifications to the specimen requirements to account for the specifics of AM processes. Critical flaws that caused failure were identified in all but two cases using optical fractography augmented with the imaging of fracture surfaces in a scanning electron microscope. The flexural strength data, analyzed following the Weibull statistics, exhibited considerable variation among the specimen sets manufactured by different laboratories. This variability correlated with the presence of many distinct critical flaws. We identified seven types of flaws that accounted for the failure of 94% of specimens. The prevalent flaws depend on the printing direction relative to the specimen's geometry. We discuss the nature of these flaws and their relation to the printing and post‐processing conditions. Removal of several types of critical flaws will significantly improve mechanical properties of ceramic parts built using vat‐photopolymerization AM.