Interfacial strength in glass fibre-polypropylene composites: influence of chemical bonding and physical entanglement

Abstract

For glass fibre–polypropylene (PP) composites, the non-polar nature of polypropylene presents a problem. The present investigation shows that it is necessary to introduce a functionalised PP, for example PP-g-MAH, in order to enhance the bond strength between the PP matrix and aminosilane treated glass fibre. To achieve a better bonding between the substances, three different systems (1–3) in addition to a reference system (0), have been investigated in this study. The two first are based on PP-g-MAH coupling agents, with different concentrations of acid anhydride groups, and the third is a directly reacting system. In the first system, the silane treated glass fibre is exposed to molten mixture of 95 wt% PP homopolymer and 5 wt% PP-g-MAH. In the second system, the silane treated glass fibre is covered by a thin layer of PP-g-MAH and thereafter exposed to the molten PP. The interfacial shear strength is highest for the systems with the pre-compounded graft-copolymer. The resulting influence of the selected coupling systems on the interfacial bond strength of single fibre composite is studied by fragmentation testing. The intermolecular shear strength between fibre and matrix increases with the intermolecular entanglement length of the PP-g-MAH and not by the degree of functionalisation. The PP-g-MAH mixed into the PP gave better results than the route of first covering the glass fibre with a thin layer of PP-g-MAH. This is explained in terms of the probability of generating entanglements and in terms of a weak boundary layer at the glass surface. This conclusion is also supported by the results from using the third principle, i.e. direct reaction between the PP matrix and azidosilane treated glass fibres.