Abstract
Lentil protein isolate (LPI) was investigated for its potential as a plant protein-based emulsifier. LPI consists mainly of globulins with high molecular weights which are relatively slow to adsorb and stabilize oil-water interfaces. Smaller proteins, such as whey protein, can stabilize the interface much faster, quickly forming a viscoelastic film that slows down the rate of droplet recoalescence, leading to smaller droplets. To increase the rate of adsorption, LPI was enzymatically hydrolyzed by pepsin at 1.5% and 4.5% degree of hydrolysis (DH), to obtain small peptides. The behavior of these peptides was studied at the oil-water interface in comparison to whey protein isolate (WPI) and native lentil protein isolate (LPI). Interfacial properties were investigated using dilatational and interfacial shear rheology in the linear viscoelastic regime (LVE) and nonlinear viscoelastic regime (NLVE) and these were related to protein characteristics and emulsion formation. The 1.5% and 4.5%DH LPI showed high surface hydrophobicity, and consisted mainly of low molecular weight peptides, which contributed to faster adsorption kinetics and consequently covered the interface faster than LPI. In dilatation, the native and hydrolyzed LPI-stabilized interfaces had comparable stiffness and were clearly weaker than WPI-stabilized interfaces, which contrasts with the results in shear deformations, where the former both had higher stiffness than WPI. Both hydrolyzed LPI and WPI formed more brittle and less stretchable interfaces compared to native LPI in both dilatational and shear rheology. In emulsification tests, native LPI produces the largest droplets, and the 4.5% DH LPI and WPI have the smallest droplet size. But, bridging flocculation was observed when emulsions were prepared with both hydrolyzed LPI, which may be attributed to inter-droplet hydrophobic interactions between small polypeptides. This can be linked to an increase in the surface hydrophobicity of hydrolyzed LPI. Thus, the use of native LPI as a stabilizer in emulsion preparation is preferable over the hydrolyzed samples, despite its larger droplet size.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.