Interfacial resistance of dual-layer asymmetric hollow fiber pervaporation membranes formed by co-extrusion

Abstract

Interface is critical for dual-layer membranes fabricated by co-extrusion and dry-jet wet spinning. In this work, for the first time, the importance of interface structure in overall membrane transport property was revealed by using Polysulfone (outer layer)/Matrimid (inner) dual-layer hollow fibers as a demonstration system. Due to the dope formulations of the two layers, dense skins came into formation at the shell side of Matrimid inner layer facing the interface. The Matrimid inner layer obtained from the dual-layer hollow fiber with the thinnest Polysulfone outer layer exhibited a flux around 1.0 × 10−3 kg/m2-s and a separation factor of ~800 in tert-butanol dehydration (feed flow rate 30 L/h, temperature 80 °C, permeate pressure 2 mbar, the same for the other tests). An estimation based on resistance model clearly indicated the dominance of Matrimid inner layer in the overall mass transfer of corresponding dual-layer membrane. As for hollow fibers with the thickest Polysulfone outer layer, the bulk substrate comprising the interfacial dense skin of Matrimid inner layer also displayed significant resistance and appreciable selectivity. Conclusively, the function of interface should not be ignored. The rule for the evolution of interface structure requires further exploration for fully understanding and utilizing the composite membrane by co-extrusion and phase inversion approach.