Abstract
The purpose of this study is to investigate the influence of adhesive types on the interfacial behavior of externally bonded basalt fiber reinforced polymer (BFRP) sheet-concrete substrate. Twelve manufactured double-lap shear samples were tested using four bonding adhesives. The strains on the surface of BFRP‐concrete joint were determined using electrical resistance strain gauge together with two‐dimensional digital image correlation technique (2D‐DIC). Experimental results show that properties of different bonding adhesives i.e., stiff (linear elastic, higher strength) and soft (nonlinear elastic, lower modulus, higher ultimate strain) has a significant impact on the failure mode, stiffness, ultimate load, strain and shear stress distribution nonetheless not so much on bond-slip relationship. The failure modes of specimens changed from interfacial debonding or cohesive failure in concrete substrate for stiff adhesive specimens to debonding in adhesive layer when soft adhesives are used. Stiff adhesive interfaces experienced higher ultimate loads from 1.1 to 1.3 times higher than soft adhesive interface. Meanwhile soft adhesives are shown to possess a lower maximum shear stress, higher interfacial fracture energy and longer stress transfer length.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
