Interfacial adhesion and water resistance of stainless steel–polyolefin improved by functionalized silane

Abstract

The adhesion strength and water resistance of stainless steel and adhesive resin composites determine the long‐term performance of wires and cables; however, adhesion at stainless steel interfaces is difficult. Herein, we prepared ethylene acrylic acid/linear low‐density polyethylene (EAA/LLDPE) blends with good mechanical and adhesive properties. Silane was anchored to the surface of stainless steel. The effects of silane functionalization on the adhesion surface were investigated by X‐ray photoelectron spectroscopy and Fourier transform infrared spectroscopy. The reaction mechanism between the stainless steel, silane, and EAA/LLDPE revealed adhesion was optimized when a 3:7 volume ratio of 3‐methacryloxypropyltrimethoxysilane (MEMO): 3‐aminopropyltrimethoxysilane (A‐1110) was used to modify the stainless steel substrate. SEM images of EAA/LLDPE film peel surfaces found the silane‐treated stainless steel substrates produced rough surfaces with a uniform void indicating the silane treatment enhanced the stainless steel and EAA/LLDPE film interaction. The stainless steel and EAA/LLDPE film adhesion and water resistance improved and the peel strength after water resistance testing at 68°C for 168 h increased from 3.18 N/cm to 9.37 N/cm compared to untreated stainless steel. Silane‐modified stainless steel and EAA/LLDPE blend film composite materials demonstrate potential for application in wires and cables used in environmental corrosion‐resistant applications. POLYM. ENG. SCI., 59:1866–1873, 2019. © 2019 Society of Plastics Engineers