Interface wear effects in ceramic composite crack opening

Abstract

For fiber-reinforced ceramic-matrix composites (CMCs), crack opening behavior controls oxidation atmosphere ingress into the internal composite, which affects the operation reliability and durability of engineering CMC components. Under cyclic fatigue loading, interface wear affects the crack opening behavior in CMCs. In this paper, the stress/cyclic-dependent crack opening behavior in CMCs is analyzed considering interface wear effect. The analytical crack opening displacement (COD) and related damage parameters (e.g., interface debonding ratio (IDR)) are determined based on the microstress analysis in the fiber and the matrix. Experimental CODs of different matrix cracks in SiC/SiC minicomposite are predicted under tensile loading. Considering cyclic-dependent interface wear effect, CODs and related damage parameters are analyzed for different cycles. Theoretical relationships between the COD, peak stress level, cycle number, and composite constitutive properties are established. Effects of constitutive properties, peak stress level, and damage state on cyclic-dependent COD and related damage parameters are discussed. Under tensile loading, with increasing tensile stress, COD first increases nonlinearly and then linearly with applied stress corresponding to change of the interface debonding from partial to complete debonding. The increasing rate of COD curve is relatively low upon initial loading due to short interface debonding range. However, the increasing rate of COD curve decrease again at high stress level at the condition of complete interface debonding. Under cyclic fatigue loading, the change of interface debonding condition with increasing applied cycles affects the COD and IDR curves.