Abstract
AbstractInterface engineering has become one of the most facile and effective approaches to improve solar cells performance and its long‐term stability and to retard unwanted side reactions. Three passivating agents are developed which can functionalize the surface and induce hydrophobicity, by employing substituted thiazolium iodide (TMI) for perovskite solar cells fabrication. The role of TMI interfacial layers in microstructure and electro‐optical properties is assessed for structural as well as transient absorption measurements. TMI treatment resulted in VOC and fill factor enhancement by reducing possible recombination paths at the perovskite/hole selective interface and by reducing the shallow as well as deep traps. These in turn allow to achieve higher performance as compared to the pristine surface. Additionally, the TMI passivated perovskite layer considerably reduces CH3NH3+ thermal diffusion and degradation induced by humidity. The un‐encapsulated perovskite solar cells employing TMI exhibit a remarkable stability under moisture levels (≈50% RH), retaining ≈95% of the initial photon current efficiency after 800 h of fabrication, paving the way towards a potential scalable endeavor.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
