Abstract
Application of triaxial ceramic commonly performed by crystalline phase analysis using X-ray diffraction (XRD) analysis. In this paper, Taguchi L18 orthogonal array layout was used as an experimental design to perform quantitative analysis of crystalline phase test. Palm Oil Fuel Ash (POFA) was employed as a secondary filler material in the triaxial ceramic composition. The parameters investigated were the type of POFA, POFA composition, molding pressure, sintering temperature, and soaking time. Meanwhile, the responses analyzed include the percentage of mullite and albite phases, where it was objected by criterion higher is better and smaller is better, respectively. The Taguchi design analysis had suggested that the highest mullite and smallest albite phase specimens were obtained at 5 wt. % of unground POFA (GPOFA), 3-ton (4-ton for albite phase) of molding pressure, 1200 °C of sintering temperature, and 180 min of soaking time.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.