Intelligent UUVs: Some issues on ROV dynamic positioning

Abstract

Intelligent unmanned underwater vehicles (UUVs) fall under two main group categories: the remotely operated vehicles (ROVs), which are characterized by remote operation and presence of a tether cable; and the autonomous underwater vehicles (AUVs), which are characterized by their autonomous behavior and absence of a tether cable. One fundamental issue of the UUV design is the dynamic position control system. This system plays a crucial role together with the sensor architecture in the degree of system autonomy that can be achieved. This paper is concerned with a few issues when dynamically positioning remotely operated underwater vehicles (ROVs). By restricting the operating regime of ROVs to slow velocity requirements the paper investigates the implementation of a few decentralized control strategies and compare their performance measures, which are assessed by simulating a nonlinear ROV system model for each control strategy. Issues concerning input tracking, disturbance rejection, and plant variations are discussed. The evaluations consider the use of linear PID feedback and feedforward variants, and a robust nonlinear control strategies applied to a full order, fully coupled, and nonlinear vehicle model. These evaluations consider a vehicle undertaking standard mission activities where the tether cable dynamics, with load estimates obtained from a lumped mass cable model, and the vehicle actuator system are present. The paper shows that much of the performance deterioration may be attributed mainly due to cable inertia. The authors also verify that the nonlinear robust control strategy does not necessarily allow for better performance over the linear feedback control strategies implemented when vehicle motions are confined to slow velocity profiles. These and other partial results will aid the design of the control system for an underwater vehicle currently under construction