Integration of SWAT and QUAL2K for water quality modeling in a data scarce basin of Cau River basin in Vietnam

Abstract

Water quality modeling in a river basin often faces the problem of having a large number of parameters yet limited available data. The important inputs to the water quality model are pollution concentrations and discharge from river tributaries, lateral inflows and related pollution load from different sources along the river. In general, such an extensive data set is rarely available, especially for data scarce basins. This makes water quality modeling more challenging. However, integration of models may be able to fill this data gap. Selection of models should be made based on the data that is available for the river basin. For the case of Cau River basin, the SWAT and QUAL2K models were selected. The outputs of SWAT model for lateral inflows and discharges of ungauged tributaries, and the observed pollutant concentrations data and estimated pollution loads of sub-watersheds were used as inputs to the water quality model QUAL2K. The resulting QUAL2K model was calibrated and validated using recent water quality data for two periods in 2014. Four model performance ratings PBIAS, NSE, RSR and R2 were used to evaluate the model results. PBIAS index was chosen for water quality model evaluation because it more adequately accounted for the large uncertainty inherent in water quality data. In term of PBIAS, the calibration and validation results for Cau River water quality model were in the “very good” performance range with ǀPBIASǀ<15%. The obtained results could be used to support water quality management and control in the Cau River basin.