Abstract
ABSTRACT A two-step process involving coagulation-flocculation followed by solar photocatalysis – based Advanced Oxidation Process (AOP) using TiO2-Reduced Graphene Oxide (TRGO) nanocomposite as catalyst has been employed for the treatment of pulp and paper mill effluent. As the effluent is loaded with a high amount of organics with initial chemical oxygen demand (COD) as high as 3516, a pre-treatment is required before applying photocatalytic treatment. Coagulation-flocculation was identified as an effective pre-treatment strategy. Among the various coagulants tested, CuSO4.5H2O showed the best % COD reduction of 84 at pH 6, at a loading of 5 g/L. The primary treatment of coagulation improved the biodegradability index from 0.23 to 0.37. TRGO photocatalyst, employed in the second stage of photocatalytic treatment was synthesised by an ultrasound assisted solvothermal method and well characterised by various spectroscopic/analytical tools. The composite was found to be an efficient solar photocatalyst and achieved 1.76 and 2.1 times more COD reduction than synthesised TiO2 and commercial P25 respectively. The final effluent after the combined treatment was neutral and the biochemical oxygen demand (BOD) and COD were 11.7 and 120 mg/L respectively which were below the given limit of National Environmental Quality Standards.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.