Integrating in situ and multiscale passive microwave data for estimation of subgrid scale snow water equivalent distribution and variability

Abstract

New multiscale research datasets were acquired in central Saskatchewan, Canada during February 2003 to quantify the effect of spatially heterogeneous land cover and snowpack properties on passive microwave snow water equivalent (SWE) retrievals. Microwave brightness temperature data at various spatial resolutions were acquired from tower and airborne microwave radiometers, complemented by spaceborne Special Sensor Microwave/Imager (SSM/I) data for a 25/spl times/25 km study area centered on the Old Jack Pine tower in the Boreal Ecosystem Research and Monitoring Sites (BERMS). To best address scaling issues, the airborne data were acquired over an intensively spaced grid of north-south and east-west oriented flight lines. A coincident ground sampling program characterized in situ snow cover for all representative land cover types found in the study area. A suite of micrometeorological data from seven sites within the study area was acquired to aid interpretation of the passive microwave brightness temperatures. The in situ data were used to determine variability in SWE, snow depth, and density within and between forest stands and land cover types within the 25/spl times/25 km SSM/I grid cell. Statistically significant subgrid scale SWE variability in this mixed forest environment was controlled by variations in snow depth, not density. Spaceborne passive microwave SWE retrievals derived using the Meteorological Service of Canada land cover sensitive algorithm suite were near the center of the normally distributed in situ measurements, providing a reasonable estimate of the mean grid cell SWE. A realistic level of SWE variability was captured by the high-resolution airborne data, showing that passive microwave retrievals are capable of capturing stand-to-stand SWE variability if the imaging footprint is sufficiently small.