INTEGRATED PASSIVE-ACTIVE SYSTEM FOR SEISMIC PROTECTION OF A CABLE-STAYED BRIDGE

Abstract

This paper presents an integrated passive-active (i.e. hybrid) system for seismic response control of a cable-stayed bridge. Since multiple control devices are operating, a hybrid control system could alleviate some of the restrictions and limitations that exist when each system is acting alone. Lead rubber bearings are used as passive control devices to reduce the earthquake-induced forces in the bridge and hydraulic actuators are used as active control devices to further reduce the bridge responses, especially deck displacements. In the proposed hybrid control system, a linear quadratic Gaussian control algorithm is adopted as a primary controller. In addition, a secondary bang-bang type (i.e. on-off type) controller according to the responses of lead rubber bearings is considered to increase the controller robustness. Numerical simulation results show that control performances of the integrated passive-active control system are superior to those of the passive control system and are slightly better than those of the fully active control system. Furthermore, it is verified that the hybrid control system with a bang-bang type controller is more robust for stiffness perturbation than the active controller with a μ-synthesis method, and there are no signs of instability in the over-all system whereas the active control system with linear quadratic Gaussian algorithm shows instabilities in the perturbed system. Therefore, the proposed hybrid protective system could effectively be used for seismically excited cable-stayed bridges.