Integrated numerical study on the coupled photon-thermal conversion process in the central solar molten salt cavity receiver

Abstract

In a solar power tower system, the concentrating and collecting subsystem, including the heliostat field and the receiver, contains some of the most costly and technically challenging components. Many types of solar receivers make up the solar power tower system. Among them, the cavity molten salt receiver has been widely applied due to its lower heat loss. The accurate simulation of the coupled heat transfer process in the cavity receiver and the prediction of receiver performance are of great importance for the receiver design and safe operation. The solar flux distribution on cavity interior surfaces is extremely non-uniform, which has great effect on the receiver thermal performance. Taking the non-uniform solar flux distribution into consideration, the photon-thermal conversion process is simulated integrally in this paper. A hybrid simulation approach, which couples Monte Carlo ray tracing and Gebhart methods, is applied to investigate the complete solar radiation transfer process in the solar power tower system with a cavity receiver and obtain the non-uniform solar flux distribution. On this basis, the coupled photon-thermal conversion process in the molten salt cavity receiver is simulated. The effects of the fluid flow layout on the receiver performance under the non-uniform solar flux distribution are particularly revealed. Also, the variation of the receiver performance with time is analyzed in detail. The results show that the solar flux distribution on the interior surfaces of the cavity receiver is extremely non-uniform, under which the molten salt flow layout has great effects on the receiver performance. In the case of flow layout that the cold molten salt flows into the receiver in the high-flux area, the temperatures of both the absorber wall and the molten salt increase rapidly along the flow path. The temperature of the whole absorber wall is relatively high, which leads to greater heat loss and less amount of hot molten salt, and even seriously, “heat transfer deterioration” near the outlet of the receiver. When the cold molten salt flows into the receiver in the low-flux area, the temperature of both the absorber wall and the molten salt increase slowly along the flow path. The temperatures of the whole absorber wall is relatively low, which results in less heat loss and larger amount of hot molten salt. Although the shape of the solar flux distribution on the interior surfaces varied greatly with time, the evolutions of the molten salt (absorber wall) temperature at different time display similar variation tendency along the flow path. Moreover, the reflective loss varies with time greatly, while the heat loss varies with time slightly.