Insulation Systems of Frame Cottages

Abstract


 The article presents studies of the exploitation characteristics of the material, the results of a full-scale survey of a residential private house insulated with expanded polyethylene, as well as the main design solutions for the insulation of a frame cottage.
 
 The features of insulation systems of low-rise buildings, including those with a frame-bearing carrier system, are considered. It has been substantiated that the use as thermal insulation of mineral-wool plates used on non-loaded structures assumes the mandatory placement of vapor barrier (usually plastic film) from the inside of the insulated surface and the windproof membrane outside. The use of a rolled foamed polyethylene as an insulating material makes it possible to realize an insulating sheath without additional layers.
 Experimental determinations of diffusion moisture absorption, water absorption upon partial immersion in water, water absorption upon full immersion in water, tensile strength in the longitudinal direction, and adhesion strength of the adhesive layer to metal were performed. It was established that the diffusion moisture absorption of samples of expanded polyethylene is 0.51-0.75%, and taking into account the weld it is 0.70-0.75%. Water absorption of samples when fully immersed in water does not exceed 0.96% by volume. The tensile strength in the longitudinal direction for products with a metallized coating is 80-92 kPa, without a metallized coating - 80-87 kPa, and for a weld - 29-32 kPa.
 A field survey showed that the humidity of the pine timber is within the normative. The expediency of warming only the outer coating of expanded polyethylene of the calculated thickness without filling the frame is justified, which, with standard air exchange and observance of the conditioning conditions, will be sufficient to maintain the microclimate in the room.